Purpose
The installation of energy meters in railway vehicles facilitates the exact
measurements of energy consumption. This serves mainly two purposes:
- provide consumption data for an exact energy billing system
- provide consumption data for the identification and assessment of energy
saving measures
Availability of energy consumption data
In diesel traction the energy supply is on-board and therefore the energy
consumed can be clearly attributed to one single vehicle (nevertheless an
additional diesel flow meter can have an additional benefit). In contrast, in
electric systems energy consumption is usually measured at the substations only
which does not allow for an exact assignment to one single vehicle, since
several vehicles may be in the same feeding section.
As a consequence, energy billing is usually based on theoretical consumption
values derived from train data or simulations of train runs. The accuracy of
such a system is limited by various factors:
- Simulation algorithms are based on models that make simplified assumptions
on real conditions. This creates a small but non-negligible inaccuracy of the
outcome.
- Simulations or calculations do not take into account the specific external
factors influencing the energy consumption of one particular train run, such
as wind, track conditions etc.
- The same is true for internal factors influencing the train run, mainly
the driver. The driving style has a significant impact on energy consumption
through such factors as use of recuperation brakes, speed pattern and
coasting.
The values derived from direct measurements by means of an energy meter do
not have these limitations.
Liberalisation of railway markets
As European railway markets are deregulated, the energy consumption of
individual trains is no longer just an internal affair of the railway operator.
In an effort to ensure the same conditions for all competitors, a clear and
transparent billing mechanism has to be introduced. Naturally, an on-board
measurement of energy consumption is not a prerequisite for billing but it does
put it on a more accurate basis.
Technical details
There are no technical specifications for energy meters on a European or
international level, although there do exist standardisation efforts. An
on-board measurement of energy consumption and data recording as well as
processing requires the following system components:
- The energy meter: The energy measurement requires measurement transformers
(voltage and current) as well as the meter itself. The whole measurement
device usually has an accuracy of at least 2%. The measurement equipment must
be protected against manipulation by unauthorised persons.
- Data collection: Depending on the needs of the operator, the equipment
will produce ¼ hour or 1 hour profiles, i.e. the on-board equipment calculates
the energy consumed in a period of 15 or 60 minutes by integrating the power
intake over this period of time. Double registering allows for a separate
collection of energy intake and recovered energy returned to the grid.
- Data recording: A memory is needed to avoid data loss in case the regular
read-out is not possible. Usually, 60 days of data storage will in most cases
be sufficient.
- Remote reading: A remote reading by GSM or GSM-R radio link improves the
efficiency of the process.
- Display: There are controversial opinions on the question whether it is
desirable to display the consumed power to the driver. While some argue that
this could be an additional incentive to reduce energy consumption, others
fear that the additional information could distract the driver from more
relevant information.
|