Technologies        
  Hauptmenu
 
    Introduction
    Database
    -  Technologies
  -  Projects
    Calendar
    Discussions
    Contact & Links
    Imprint & Disclaimer
    Sitemap
 
 


     
 
Content
 
back to list go back to technology list      previous previous technology  next technology  next

   On-board use of braking energy in diesel-electric stock  evaluated  
Modern diesel-electric vehicles can be equipped with the capacity to use some of the energy recovered during braking for auxiliary and comfort functions.
Technology field: Regenerative braking and energy management
open main section General information
close main section General criteria
  open sub-section Status of development: in use
  Time horizon for broad application: 2 - 5 years
  Expected technological development: basically exploited
  Benefits (other than environmental): small
  Barriers: low
  Applicability for railway segments: medium
    Type of traction:  diesel
    Type of transportation:  passenger - main lines, passenger - regional lines, passenger - suburban lines, freight
    Grade of diffusion into railway markets:
  Diffusion into relevant segment of fleet: < 5%
  Share of newly purchased stock: (no data)
  Market potential (railways): medium
close main section Environmental criteria
  close sub-section Impacts on energy efficiency:
  Energy efficiency potential for single vehicle: 2 - 5%
  Energy efficiency potential throughout fleet: 1 - 2%
   

There are no data available on the in-use energy savings realised by the ÖBB 2016 locomotives.

In order to make an estimate of the potential, on has to look at the power management and the layout of the locomotive: The motors have a traction power of 1600 kW and a braking power of 1000 kW. If maximum braking power is applied, these 1000 kW are fed into the DC link. The part of this power that can be used for auxiliaries or train bus supply is drawn from the DC link, the rest is dissipated in the resistors. The resistor is automatically "switched on" if the voltage in the DC link exceeds a certain limit. The maximum power intake of auxiliaries is about 50 kW. In passenger operation, there is an additional ~ 460 kW maximum power drawn by the train bus supply for comfort functions, mainly coach heating.

These data allow for a rough estimate of the energy saving potential in freight and passenger trains.

Locomotives in freight operation

A maximum of ~5% of the recovered energy can be used on board. In addition, the potential for regenerative braking in freight operation is low (< 5%). Therefore the energy efficiency potential through the use of brake energy for auxiliary functions is almost negligible.

Locomotives in passenger operation

A maximum ~50% of the recovered braking power is consumed by on-board functions (auxiliaries comfort functions). This is however only the case in long passenger trains in winter. Usually the potential will be lower. An average of 20% could be realistic. In view of the potential for regenerative braking between about 15 % (main lines) and 35% (regional lines), the overall saving potential is between 3 and 7%. However, this is still very optimistic since it is based on the assumption that the dynamic brakes are used exclusively. In real operation, energy savings of 2% in main line and 5 % in regional line operation seems realistic.

DMUs

There is no data available on the use of recovered braking energy for comfort functions in DMUs. In modern diesel-electric stock using 3-phase traction equipment, there should be no principal barriers.

  Other environmental impacts: neutral
    (no details available)
open main section Economic criteria
no data available Application outside railway sector (this technology is railway specific)
open main section Overall rating
References / Links:
Attachments:
Related projects:
Contact persons:
 date created: 2002-10-09
 
 
© UIC - International Union of Railways 2003
 
Aktionmenu
 
 Your contribution
   add technology
 Views of this page
   show overview
   show evaluation
   show details
 Print options
   print data sheet
   print screen
 Help
   Evaluation briefing
   Technology list
    French - German