There are no data available on the in-use energy savings realised by the ÖBB
2016 locomotives.
In order to make an estimate of the potential, on has to look at the power
management and the layout of the locomotive: The motors have a traction power of
1600 kW and a braking power of 1000 kW. If maximum braking power is applied,
these 1000 kW are fed into the DC link. The part of this power that can be used
for auxiliaries or train bus supply is drawn from the DC link, the rest is
dissipated in the resistors. The resistor is automatically "switched on" if the
voltage in the DC link exceeds a certain limit. The maximum power intake of
auxiliaries is about 50 kW. In passenger operation, there is an additional ~ 460
kW maximum power drawn by the train bus supply for comfort functions, mainly
coach heating.
These data allow for a rough estimate of the energy saving potential in
freight and passenger trains.
Locomotives in freight operation
A maximum of ~5% of the recovered energy can be used on board. In addition,
the potential for regenerative braking in freight operation is low
(< 5%). Therefore the energy efficiency potential through the use of brake
energy for auxiliary functions is almost negligible.
Locomotives in passenger operation
A maximum ~50% of the recovered braking power is consumed by on-board
functions (auxiliaries comfort functions). This is however only the case in
long passenger trains in winter. Usually the potential will be lower. An average
of 20% could be realistic. In view of the potential for regenerative braking
between about 15 % (main lines) and 35% (regional lines), the overall saving
potential is between 3 and 7%. However, this is still very optimistic since it
is based on the assumption that the dynamic brakes are used exclusively. In real
operation, energy savings of 2% in main line and 5 % in regional line operation
seems realistic.
DMUs
There is no data available on the use of recovered braking energy for comfort
functions in DMUs. In modern diesel-electric stock using 3-phase traction
equipment, there should be no principal barriers. |